by NRA Staff -
Sunday, July 15, 2012
There should be a gap of about 0.030 inches between the bottom edge of the barrel throat and the top of the feed ramp in the frame.
A Dremel tool can be used to carefully throat an M1911 barrel.
Polishing the frame feed ramp is often best accomplished simply with 600-grit or finer sandpaper wrapped around a wooden dowel.
Ejection reliability of a gun with the high G.I. ejection port is enhanced by lowering the port and flaring it at the rear.
Frames for different calibers have different feed ramps. Shown here are frames for the .45 ACP and 9 mm Luger.
Guide rod heads, particularly of aftermarket, full-length guide rods, may contact the lower barrel lugs and should be relieved for clearance.
A properly throated M1911 barrel is shown next to an original G.I. barrel with its minimal throat.
In addition to fluting the rear of the ejection port, a gunsmith will also clear or bevel the inside edge of the port to enhance ejection reliability.
Beveling and flaring the extractor claw helps the case rim slide under the claw.
A shallow detent or dimple in the slide stop face can prevent the slide stop from inadvertently rising and causing the slide to lock back prematurely.
E-mail your comments/questions about this site to:EmediaRifleman@nrahq.org For questions/comments about American Rifleman magazine, please e-mail:Publications@nrahq.org You can contact the NRA via phone at: NRA Member Programs1-800-672-3888
To advertise on American Rifleman, visit nramediakit.com for more information
Get the American Rifleman Insider newsletter for at-a-glance access to industry news, gear, gun reviews, videos and more—delivered directly to your Inbox.