Colt Bisley Revolver

posted on January 3, 2011
** When you buy products through the links on our site, we may earn a commission that supports NRA's mission to protect, preserve and defend the Second Amendment. **
20111310043-img_3937_f.jpg

Named after the shooting range where the British National Rifle Ass’n had held matches since 1890, the Bisley was a target version of the Single Action Army (SAA). But until fairly recently, the Bisley was overshadowed by its more romanticized older brother.

This is ironic, for the Bisley is part of the Colt single-action family; it uses many of the same components, including the cylinder, barrel and ejector rod, thus maintaining a basic SAA layout. But there are some subtle and not-so-subtle differences. Most obvious is the swept-under grip, which enables the Bisley to hang better in the hand; the enlarged trigger guard and wide, curved trigger for better control; and the wavy lowered hammer spur for easy cocking with the ball of the thumb. Plus, the barrel is stamped “(BISLEY MODEL).” Less obvious is the different mainspring, the deeper frame and the backstrap screws that affix it to the frame under the grips. In addition, in order to reach the cylinder ratchets, the hammer hand is longer than that of the Model P.

The Bisley, produced from 1894 until 1915, reflected a growing interest in target shooting. It was serial-numbered sequentially with the Peacemaker, spanning the ranges from 156300 to 331916, with a total of 45,326 made. Bisleys were blued and case-hardened or nickeled, and made with 4¾-, 5½- and 7½-inch barrel lengths. Special-order finishes and engraving were available but rare. The Bisley was offered in 18 chamberings from .32-20 Win. to .455 Eley. Even though this was a target gun, Colt retained the SAA’s rudimentary grooved topstrap, although 976 flat-top target Bisleys were made. But because of its shootability, it is likely more Bisleys were used on the open range than the target range.

That is the case with this well-used but cared-for 30 percent gun, which locks up tight and, while exhibiting holster wear, still retains case hardening in protected areas and some bluing on the backstrap, trigger guard and portions of the barrel. The initials “CRW” are crudely etched in the butt and the period stag grips add to its frontier aura. This gun was purchased at auction 10 years ago for $850—a bargain even then—but today, according to the “Blue Book of Gun Values,” it is worth $2,200.

Gun: Colt Bisley
Caliber: .38-40 Win.
Condition: 30 percent—NRA Good (Modern Gun Condition Standards)
Manufactured: 1900
Value: $2,200

Latest

SAAMI approves 25 Win. RPM and 8.6 BLK
SAAMI approves 25 Win. RPM and 8.6 BLK

SAAMI Accepts and Standardizes Two New Cartridges

Both 8.6 Blackout and .25 Winchester RPM are now SAAMI-approved cartridges.

Preview: Inforce ARC 650 LR-M

Measuring 5.6 inches long with a 1.4-inch bezel, the Inforce 650 LR-M is built for hard use within a 6061-T6 aluminum body that is then Type III hardcoat anodized for added durability and abrasion resistance.

A vz. 61 Skorpion For Less: The Titus Arms TA61

This TA61 version of the famous Czech vz. 61 Skorpion is affordably priced, thanks to a polymer lower receiver developed by Titus Arms.

New for 2026: Inglis Manufacturing 2035 Pistol

Inglis Manufacturing has introduced the 2035, its updated take on the storied Hi Power.

I Carry: Smith & Wesson Model 432 UC Revolver in a DeSantis Holster

In this week's episode of "I Carry," we have a Smith & Wesson Model 432 UC revolver carried in a DeSantis Holsters Super Fly pocket holster along with a Cold Steel Frenzy pocket knife.

The Armed Citizen® Feb. 13, 2026

Read today's "The Armed Citizen" entry for real stories of law-abiding citizens, past and present, who used their firearms to save lives.

Interests



Get the best of American Rifleman delivered to your inbox.